Further Settings; Headrests; Adjusting The Lateral Head Supports; Adjusting The Integrated Head Support - Otto Bock Kimba Neo Instructions For Use Manual

81

7.2.4 Further settings

The following adjustment tasks are described in more detail in the included instructions for use (user):
• Adjusting the back angle
• Adjusting the seat angle (seat tilt)
• Adjusting the adjustable armrests

7.3 Headrests

7.3.1 Adjusting the lateral head supports

1) Open the zip at the top of the pad (see fig. 6) and push the pad behind the seat to the side.
2) Loosen the wing nuts on the rear of the back support.
3) Adjust the distance by moving the support pads in the slotted holes (see fig. 82, item 1).
4) Adjust the height by shifting the support pads in the bore holes of the back support (see fig. 82, item 2).
INFORMATION: The height of the lateral head supports can also be changed by adjusting the back
support height (see Page 32).
5) Firmly tighten the wing nuts.
6) Close the zip at the top of the pad.
82

7.3.2 Adjusting the integrated head support

To adjust the width in the head area, up to 3 pads (see fig. 83, no. 1) with a thickness of 10 mm each can be
attached on each side:
1) Open the zipper of the padding cap (see fig. 6) and remove the back support pad from the integrated head
support.
2) Attach up to 3 pads on each side of the head support (see fig. 83, no. 1, see fig. 84, no. 1).
3) Return the back support pad and fasten it.
Kimba Neo
Settings
33