Positioning The Foam Wedge: Concave Head Support; Adjusting The Head Support Position - Otto Bock Kimba Neo Instructions For Use Manual

2) Set the angle.
3) Tighten the Allen head screw on the hinge to 7 Nm (see fig. 86, no. 1).
4) Check that the support is securely attached.
b) Adjusting the distance of the lateral pads to the middle pad
1) Loosen the Allen head screws on the back (see fig. 86, no. 2).
2) Adjust the distance by moving the hinge.
3) Tighten the Allen head screws to 5 Nm (see fig. 86, no. 2).
4) Check that the support is securely attached.
86

7.3.3.3 Positioning the foam wedge: Concave head support

1) Open the hook-and-loop closure on the cover and remove the cover (see fig. 87).
2) Position the wedge in the centre directly on the foam material (see fig. 88).
3) Put on the cover and fasten the hook-and-loop closure (see fig. 87).
87

7.3.3.4 Adjusting the head support position

The position of the head support can be adjusted using the wing nuts on the connecting bridge.
1) Loosen the thumb screws (see fig. 89, no. 1).
2) Adjust the position of the head support as needed.
3) Tighten the thumb screws.
4) Verify that the head support is firmly engaged.
Kimba Neo
88
Settings
35