Positioning Belts; Strap Guide - Otto Bock Kimba Neo Instructions For Use Manual

Hide thumbs Also See for Kimba Neo:

Table of Contents

Installing options/accessories

6.2 Positioning belts

CAUTION

Incorrect approach to the adjustment process

Injuries, malpositions, user discomfort due to adjustment errors

► The belt system may only be installed by qualified personnel.

► The qualified personnel is responsible for the individual positioning and fitting of the belt system.

► Adjusting the belt system too tightly may lead to unnecessary pain or user discomfort.

► Adjusting the belt system too loosely can cause the user to slide into a dangerous position. In addition, the

fastening snaps could open unintentionally if they slide against hard parts of clothing (e.g. buttons).

► For proper installation and adjustment, follow the instructions for use included with the product.

For improved belt guidance in the pelvic area, strap guides must be mounted with the following option (mounting

point see fig. 18, no. 1):

•

Lap belt of the five-point belt

1) Attach the strap guide at the small bore hole on the inside of the rear seat frame (see fig. 19, no. 1).

2) Guide the screw through the small bore hole from the outside (see fig. 19, no. 2) and screw it into the strap

guide.

3) Put on the washer and cap nut from the inside. Do not fully tighten yet.

4) Position the strap guide so the D-ring lies over the large bore hole (see fig. 18, no. 1).

5) Tighten the washer and cap nut.

Kimba Neo

Table of Contents