Otto Bock Kimba Neo Instructions For Use Manual page 16

Installing options/accessories
Mounting the 4-point lap belt
1) Mount the 3-slot mounting brackets (see fig. 29, no. 5) at the bore holes on the bottom of the seat plate.
INFORMATION: It should be possible to turn the 3-slot mounting brackets with some resistance if
needed.
2) Turn the 3-slot mounting brackets (see fig. 29, no. 5) to the outside.
3) Lay the 4-point lap belt on the seat.
4) Guide the upper belts (see fig. 29, no. 2) sideways under the hip supports (see fig. 31).
With adjustable arm supports: Guide the upper belts behind the arm support holder (see fig. 31, no. 1).
Guide the positioning belts (see fig. 29, no. 3) in front of the arm support holder.
5) Thread the ends of the belt through the 3-slot mounting brackets (see fig. 28). Adjust the belt length and tight­
en the belt.
6) If necessary, cut off protruding belt ends and seal the loose ends by applying heat (e. g. with a lighter).
30
16
31
Kimba Neo