Settings
89
7.4 Positioning aids
CAUTION
Improper adjustment
Crushing or pinching due to adjustments which are too tight
► Do not pinch the user when sliding in the product.
7.4.1 Adjusting the thoracic supports
1) Loosen the wing nuts on the rear of the back support.
2) Adjust the width and height by moving the support pads in the slotted holes (see fig. 90).
INFORMATION: If necessary, you can adjust the height of the support pads by shifting the mounting
screws in the slotted hole of the back support.
3) Firmly tighten the wing nuts.
90
7.4.2 Adjusting the pommel
The pommel can be adjusted as follows:
•
Shifting the mounting screw to other bore holes or slotted holes of the seat plate (see fig. 44, see Page 21)
•
Moving the pommel in the slotted hole (see fig. 45, see Page 21
7.4.3 Adjusting the sternum strap
INFORMATION
The application of the product is described in the Instructions for Use (User).
The sternum strap can be adjusted as follows:
•
Adjusting the belts using the pairs of clip buckles at the rear of the back support (see fig. 50, item 2 and 3, see
Page 22)
•
Adjusting the belts using the sewn-on clip buckles on the sternum strap (see fig. 48, item 5, see Page 22)
36
Kimba Neo