Adjusting The Individually Adjustable Head Support; Adjusting The Angle Of Inclination; Adjusting The Width: Head Support, Three-Piece, Angle-Adjustable - Otto Bock Kimba Neo Instructions For Use Manual

Settings
83

7.3.3 Adjusting the individually adjustable head support

CAUTION
Incorrect settings
Hitting components due to violent head movements of the user
► Do not position yourself behind the head support during adjustment, but at its side.
INFORMATION
Observe the following when adjusting the head support:
► Position the back of the user's head as close as possible to the contact surface of the head support (maxim­
um distance: 50 mm).
► Adjust the centre of the contact surface to the height of the top of the ears.
INFORMATION
To mount the head support: see Page 10

7.3.3.1 Adjusting the angle of inclination

1) Loosen the Allen head screws (see fig. 85, no. 1).
2) Adjust the angle of inclination.
3) Tighten the Allen head screws to 5 Nm (see fig. 85, no. 1).
4) Check that the support is securely attached.
85

7.3.3.2 Adjusting the width: Head support, three-piece, angle-adjustable

The width of the head support can be adjusted as follows:
• Via the angle of the lateral pads
• Via the distance of the lateral pads to the middle pad
a) Adjusting the angle of the lateral pads
1) Loosen the Allen head screw on the hinge (see fig. 86, no. 1).
34
84
Kimba Neo