Case CX130C Operator's Manual page 82

8. Display mode selector button
Press the display mode selector button to select the
set of information visualized on the display:
The operating mode shows gauges, icons, warning
and messages related to the functioning of the ma-
chine.
The user information mode provides access to the
configuration tabs for the set up of the main function-
alities of the machine.
The mode of the display toggles every time the se-
lector button is pressed.
NOTICE: During machine operation, make sure to
select the operating mode of the display.
9. Camera view selector button
If the rear camera is equipped, press the camera
view selector button to select the operating mode of
the display between the following modes:
MODE-1: Indicators + Machine information
3 - CONTROLS AND INSTRUMENTS
7
0C5B55F6
8
SMIL16CEX1658AA
9
0C5B55F6
MODE-2: Camera image + Machine information
MODE-3: Camera images + icons
The operating mode of the display toggles every time
the selector button is pressed.
10. Hour meter/Trip meter button
The information is shown on the bottom of the display
in the operating MODE-1. The hour meter indicates
the total engine operating hours in units of 0.1 h (
6 min ). The hour meter cannot be reset. The trip
meter allows to set a partial operating hour counter,
which can be reset to 0 h at any time. The hours
are indicated in units of 0.1 h ( 6 min ). To reset the
trip meter press and hold the hour meter button while
the trip meter is displayed. The displayed engine
operating hours will be reset to 0 h. The hour meter
is displayed by default. To display the trip meter,
press the hour meter button: the trip meter will be
thus displayed for approximately 1 min, after which
the hour meter will be displayed again.
NOTE: The display disappears when the starter key
is turned to OFF position. The hour meter can be
anyway displayed for 20 s by pressing the hour meter
button.
NOTE: The hour meter is not displayed in the oper-
ating MODE-2 or MODE-3.
3-36
10
3PZT8U-003Z
11
3PZT8U-004Z