Table of Contents
Advertisement
CX130C with blade
Select the H work mode.
Align the machine to the trailer, so as the blade faces the
trailer ramps. Fully raise the blade.
NOTICE: Starting from this position, the travel control
levers must be pushed forward to move on the ramps and
on the trailer bed. Confirm the travel control directions
before start moving onto the ramps.
Get close to the ramps and operate the arm and bucket
controls so that the arm is slightly extended and the bot-
tom side of the bucket is about 20 cm (7.9 in) above the
trailer bed.
Slowly climb the trailer ramps keeping the bucket close to
the trailer bed. Slowly travel on the trailer bed to reach
the resting position, giving particular attention to the at-
tachment so as not to touch the trailer bed.
After reaching the resting position, lower the blade on the
supporting block.
Make sure that there is enough space between the block
and the tracks to route the tie-down chains.
Slowly turn the upper structure 180°.
5 - TRANSPORT OPERATIONS
5-4
6
SMIL20CEX0023AA
7
SMIL20CEX0026AA
8
SMIL19CEX2664AA
9
SMIL20CEX0027AB
Advertisement
Table of Contents
