Table of Contents
Advertisement
Replacement of belt
NOTICE: If the belt breaks, the message ALTERNATOR is displayed. Stop the engine, remove the starter key, and
then replace the belt.
1. Loosen the lock nut (1) and the mounting bolt (2).
2. Lightly tighten the lock nut (1) until its seating face
touches.
3. Remove the belt from the pulley to pull it out from
cut out portion of the fan guide.
4. Insert the new belt from the fan guide to mount
it by aligning it to groove of each pulley. Rotate
the adjust bolt (3) to adjust tension of the belt to
become standard value.
5. Tighten the lock nut (1) and the mounting bolt (2)
that have been loosened with specified torque.
6. After adjustment, run the engine in idling speed for
approximately 5 min, and then stop the engine to
re-check tension of the belt.
6 - MAINTENANCE
6-34
4
SMIL15CEX9110AB
Advertisement
Table of Contents
