Fuel Pre-Filter - Case CX130C Operator's Manual

Fuel pre-filter

WARNING
Fire hazard!
When handling diesel fuel, observe the following precautions:
1. Do not smoke.
2. Never fill the tank when the engine is running.
3. Wipe up spilled fuel immediately.
Failure to comply could result in death or serious injury.
Replace the fuel pre-filter elements every 500 h
NOTICE: Replace fuel pre-filters when the text message FUEL FILTER is displayed. The filters could be clogged
earlier than 500 h depending on the fuel quality and other conditions.
NOTICE: Do not work in any environment in which anything other than fuel will get into fuel lines. (Sites with strong
wind, blowing dust, etc.). Wash hands before operations. Do not use gloves. Do not open the packaging for the filter
kit until you start the installation work. Do not reuse any fuel remaining within the cover. For persistent dirt within the
cover, wipe it off with a clean rag, then clean with clean diesel fuel. Do not use parts cleaner because it could affect
the case cover. Do not touch the inside of the element. Completely wipe off any spilled fuel after changing the filter
element.
NOTICE: Use of fuel filters other than CASE CONSTRUCTION genuine components, is prohibited.
1. Place a container with an appropriate capacity under
the pre-filters.
2. Close the fuel cut valve.
3. Loosen the drain plug (1), the air bleed plug (2), and
drain from the left-hand fuel pre-filter.
4. Clean the area around the pre-filter body, and then re-
move it with the specific wrench supplied with the ma-
chine.
5. Install a new filter element. Replace the seal on the
pre-filter body, and then install the body on the pre-filter
head by turning it manually.
NOTICE: never fill the pre-filter body with fuel before the
installation.
6 - MAINTENANCE
6-43
W0099A
1
SMIL17CEX0184AA
2
SMIL17CEX0182AA