Table of Contents
Advertisement
Control buttons
1. Travel mode select button
The selection toggles between slow speed mode
("Turtle") and fast speed mode ("Rabbit") every time
the travel mode selector switch is pressed.
NOTICE: perform all changes to the travel mode while
the machine is stopped.
Use the "Turtle" mode to travel on slope, off-road or soft
ground.
Use the "Rabbit" mode to travel on a hard, flat, maintained
road.
NOTE: the slow speed mode is automatically selected
when the engine is started.
NOTE: if the fast speed mode is selected on the machine,
it automatically switches to slow speed mode when the
load increases on uphill road, and automatically returns
to fast speed mode as the load decreases.
2. Fuel consumption indicator button
Push to show alternately on the display the cumula-
tive average fuel consumption or the cumulative fuel
consumption amount.
- Cumulative average fuel consumption: displayed in
L/hr.
- Cumulative fuel consumption: displayed in L.
Push the fuel consumption indicator button for 3 sec-
onds to reset the cumulative average fuel consump-
tion and cumulative fuel consumption amount.
3. Attachment selection button
When using a hydraulic attachment, press the button
to set the auxiliary hydraulic circuit to the pattern that
properly matches the type of attachment used.
Set the breaker mode for using a single acting hy-
draulic attachment such as hydraulic breaker. The
breaker icon appears on the display.
Set the crusher mode for using a double acting hy-
draulic attachment such as hydraulic crusher. The
crusher icon appears on the display.
NOTICE: before changing the setting of the auxiliary
hydraulic circuit, stop operation and set the machine
in parking position.
4. Wiper button
3 - CONTROLS AND INSTRUMENTS
SMIL18CEX0535EB
5. Windshield washer button
6. Working lights button
7. Idle mode button
3-35
6
The button sets three operating conditions: "Off", "In-
termittent" and "Continuous".
When the button is pressed to operate the wiper inter-
mittently, (I) is displayed on the monitor.
When the button is pressed again to operate the wiper
continuously, (II) is displayed on the monitor.
When the button is pressed again to stop the wiper,
"Off" is displayed on the monitor.
NOTICE: Do not operate the wiper when the front
glass is dry. Doing so could damage the wiper.
Press and hold the windshield washer button to acti-
vate the wiper and the washer to clean the windshield.
Release the button to stop the cleaning operation.
NOTICE: Do not operate the washer when the reser-
voir is empty. Doing so could damage the electric
pump.
Press the working lights button to turn on the working
lights on the front of the machine.
Press the button again to turn the working lights off.
Press the button to select the automatic control mode
of engine idling or stopping.
If auto idle mode is selected, the engine speed drops
automatically to low idle if any lever or pedal is not
operated for 5 s. The auto idle icon appears on the
display. To restore the engine speed, operate any
control lever, or turn the engine speed throttle.
If auto stop mode is selected, the message IDLE
SHUT DOWN is displayed, an alarm sounds, and
the engine stops automatically 10 s thereafter if the
engine speed is kept at 1200 RPM or below and the
gate lock lever is kept in lock position for 3 min. The
auto stop icon appears on the display
If the sequence of auto idle and auto stop is selected,
auto idle activates as described before, and if the gate
lock lever is also set to the lock position, idle shutdown
eventually activates after 3 min. The combined icon
appears on the display.
NOTE: To restart the engine, turn the starter key to
OFF position and then start the engine.
Advertisement
Table of Contents
