Dozer Blade Control Lever - Case CX130C Operator's Manual

Dozer blade control lever

WARNING
Hazard to bystanders!
ALWAYS make sure the work area is clear of bystanders and domestic animals before starting this
procedure. Know the full area of movement of the machine. Do not permit anyone to enter the area
of movement during this procedure.
Failure to comply could result in death or serious injury.
The dozer blade control lever is located beside the right-
hand console. Basic operation of dozer blade control
lever:
• Pull the lever to raise the dozer blade.
• Push the lever to lower the dozer blade.
The operation of the dozer blade stops when the lever is
released. The lever returns to the neutral position.
Use the blade only for light work such as dozing of soft
soil or mud.
Do not forcibly push down or dig deeply with the blade.
When operating in an area with many rocks and stones,
pay attention not to damage the blade.
During blade operations, avoid application of concen-
trated or lateral load to the blade. Severe damages may
be caused to the blade structure.
When the blade is used as an outrigger during the opera-
tion, check that the ground has the sufficient strength, and
be sure that the edge surface of the blade is contacting
the ground uniformly. Severe damages may be caused
to the blade structure if the machine is supported only at
one side of the blade.
NOTICE: Make sure to lower the blade to the ground be-
fore stopping machine operation.
If the engine is stopped with the blade in raised position,
it is still possible to lower the blade proceeding as follows:
1. Turn the starter key to ON position.
2. Set the gate lock lever in unlock position.
3. Push the blade control lever to lower the dozer blade.
3 - CONTROLS AND INSTRUMENTS
3-27
W0245A
1
SMIL17CEX0197BA