Page 2
Number) of your machine so your Dealer can provide the correct manuals for your machine. NOTE: Case, LLC reserves the right to make improvements in design or changes in specifications at any time without incurring any obligation to install them on units previously sold.
Learns and practices safe use of machine controls in a safe, clear area before operating this machine on a job site. It is your responsibility to observe pertinent laws and regulations and follow CASE instructions on machine operation and maintenance.
Always keep this manual in the operators compartment. Make sure it is always complete and in good condition. If you wish to obtain extra copies, or copies in languages other than that of the country of use, consult your CASE Dealer.
Page 6
FOR ORDERING For ordering parts and service, inform an authorized dealer of your machines Serial Number and Engine Serial Number stamped in the locations, and Hourmeter read, shown on the illustrations below. For future reference, record these Serial Numbers in the spaces provided below: MACHINE No.
Page 7
NOTES Find manuals at https://best-manuals.com Find manuals at https://best-manuals.com...
2. Operation, inspection, and maintenance should cedures for this machine according to methods rec- be carefully carried out, and safety must be given ommended by CASE. the first priority. Messages of safety are indicated with marks. The safety information contained in 5.
Page 10
Operating, Maintaining The proper and safe lubrication and maintenance or Repairing this machine. for this machine, recommended by CASE, is out- 2. Always wear protective glasses and protective lined in this OPERATORS MANUAL for this machine.
Page 11
SECTION 1 - SAFETY PRECAUTIONS 8. Use steps and grab handles when mounting or 16. Do not damage wiring during removal opera- dismounting a machine. Clean any mud, grease, tions. Reinstall the wiring so it is not damaged oil or debris from steps, walkways or work plat- nor will be damaged in operation of the machine forms before using.
PM1-03 reference. Should the OPERATION & ZL11V04204 MAINTENANCE MANUAL become lost or damaged, contact an authorized dealer to order the OPERATION & MAINTENANCE MANUAL. In the case of ROPS canopy, keep this manual in the storage box of the roof.
Prepare beforehand the communication means in case of any emergency, and take note of telephone numbers for emergency contact. PV1-05 G. ENSURE SAFETY AT THE WORK SITE...
Page 14
SECTION 1 - SAFETY PRECAUTIONS I . SIGNS, SIGNALS & FLAGMEN Install signs on soft shoulders and ground areas, have a flagman direct the operation if necessary. The operator should note marks and follow signals from the flagman. All personnel should know the meaning of the signs, marks, and signals.
CASE. Read, understand and follow all instructions in the manual accompanying the optional attachment. Use of any optional attachment not approved by CASE in writing, can cause serious injury to personnel, damage to the machine and its components and shorten the life of the machine.
Page 16
R. HOW TO HANDLE LIFE HAMMER-CAB only A life hammer is provided on the right side of cab. In case of emergency, take the life hammer, break the cab glass, and escape from the cab. In addition, the life hammer is equipped...
Page 17
SECTION 1 - SAFETY PRECAUTIONS U. USE CAUTION NEAR NOISE If noise is high during operation, hearing loss may result. Approved hearing protection should be used if personnel will be exposed to high noise levels for a long period of time. PV1-20 V.
SECTION 1 - SAFETY PRECAUTIONS A. PASSENGERS This equipment is not intended or designed for the transportation of persons. Never allow persons to ride on the machine. Serious injury or death can result from allowing passengers on or in the machine. PV1-22 B.
Page 19
CONDITION WHERE THE TRAVEL Make certain of the location of the travel motors DIRECTION IS REVERSED before operating travel. Pay attention that in the case where the travel motors are in the front side, the travel function TRAVEL is reversed.
SECTION 1 - SAFETY PRECAUTIONS I . SWINGING FUNCTION Make certain the swing area of machine is clear of all persons and obstacles before operating swing controls. Sound horn before swinging machine. If necessary, have a flagman signal operator during operation to help prevent injury to persons or damage to obstacles and equipment.
Page 21
This as a preview PDF file from best-manuals.com Download full PDF manual at best-manuals.com...