Table of Contents
Advertisement
Starting the engine with booster batteries
WARNING
Improper operation or service of this machine
can result in an accident.
An error connecting auxiliary starting cables or
short-circuiting battery terminals can cause an
accident. Connect auxiliary starting cables as
instructed in this manual.
Failure to comply could result in death or seri-
ous injury.
Make sure that the booster battery voltage corresponds
to the voltage system of the machine 24 V.
Make sure that the starter key is in OFF position and
the gate lock lever in inward position.
Make sure to use supply cables of appropriate dimen-
sions (at least 50 mm² (0.1 in²).
1. Connect one terminal of the positive jumper cable
(P) to the positive (+) pole of the machine batteries.
2. Connect the other terminal of the positive jumper
cable (P) to the positive (+) pole of the booster
batteries.
3. Connect one terminal of the negative jumper cable
(N) to the negative (-) pole of the booster batteries.
4. Connect the other terminal of negative jumper ca-
ble (N) to the upper frame of the machine (ground).
Turn the starter key to ON position and start the engine.
After the engine has started proceed as follows:
1. Disconnect the terminal of negative jumper cable
(N) from the upper frame of the machine (ground).
2. Disconnect the other terminal of the negative
jumper cable (N) from the negative (-) pole of the
booster batteries.
3. Disconnect the terminal of the positive jumper ca-
ble (P) from the positive (+) pole of the booster bat-
teries.
4. Disconnect the other terminal of the positive
jumper cable (P) from the positive (+) pole of
machine batteries.
6 - MAINTENANCE
W0263A
6-32
5
SMIL15CEX5131AA
Advertisement
Table of Contents
