Table of Contents
Advertisement
6. Tighten the body with the specific wrench. The tighten-
ing torque must be 28 – 32 N·m (20.65 – 23.60 lb ft)
7. Replace the seal of the drain plug (1), and attach the
drain plug (1). The tightening torque must be 2 – 3 N·m
(1.48 – 2.21 lb ft).
NOTE: Never reuse the seal of the filter body and the seal
of the drain plug (1). They shall always be replaced with
new seals.
8. Tighten the air bleed plug (2). The tightening torque
must be 8 – 12 N·m (5.9 – 8.9 lb ft)
NOTICE: Overtightening can damage the seals.
9. If the additional pre-filter on the right-hand side of the
compartment is equipped, repeat steps 3 to 8 to replace
the element of the other fuel pre-filter.
10. Bleed the fuel system. Refer to page 6-9.
6 - MAINTENANCE
6-44
3
QOIPZB-010
4
SMIL17CEX0182AA
Advertisement
Table of Contents
