Case CX130C Operator's Manual page 137

Machine setup
Accurately clean the machine undercarriage and tracks to
prevent mud or debris from skidding during transport.
Make sure to deactivate the auto idle function and the auto
shut-down function. Press the idle mode button (1) until
any idle icon on the display turns off.
Press the travel mode selector button (2) to select the low
travel speed. The "Turtle" icon appears on the display.
Loading the machine on a rear loading type trailer (with front equipment installed)
If any heavy attachment is fitted on the machine, such as a hydraulic breaker or a hydraulic crusher, remove the
attachment before loading the machine onto the trailer. Refer to the Operator's Manual of the attachment, and strictly
follow the specific procedure to remove the attachment from the machine.
CX130C – CX130C LC
Select the H work mode.
Align the machine to the trailer, so as the travel motors
face the trailer ramps.
NOTICE: Starting from this position, the travel control
levers must be pulled backward to move on the ramps
and on the trailer bed. Confirm the travel control direc-
tions before start moving onto the ramps.
Get close to the ramps and operate the arm and bucket
controls so that the arm stands vertical and the bottom
side of the bucket is about 20 cm (7.9 in) above the trailer
bed.
Slowly climb the trailer ramps keeping the bucket close to
the trailer bed. Slowly travel on the trailer bed to reach
the resting position, giving particular attention to the at-
tachment so as not to touch the trailer bed.
Slowly turn the upper structure 180°.
5 - TRANSPORT OPERATIONS
5-3
3
SMIL18CEX0768AB
4
SMIL13CEX2720AB
5
SMIL20CEX0030AA