LOCKING
Pull the locking pin into the pedal notch as shown.
CT02C045
DOZER BLADE CONTROL LEVER (IF
EQUIPPED)
This lever is used to operate the dozer blade.
Pull the lever, the dozer blade rises.
Push the lever, the dozer blade lowers.
The operation of the dozer blade stops when the
lever is released. The lever returns to the neutral
position.
With the engine stopped, if the dozer blade is in the
raised position, it is still possible to lower it using the
control lever until it touches the ground.
WARNING: Before
blade, make sure that there is no one
standing in its working area.
CT02C041
6-34551NA
CHAPTER 3 - INSTRUMENTS AND CONTROLS
Figure 36
operating the dozer
Figure 37
Issued 8-04 Bur
CAB LIGHT
Located on top of the cab on the left-hand side, the
lighting is controlled by a switch built into the lamp
bracket.
NOTE: To replace bulbs, see Replacing a bulb in the
Electrical system section.
CT02C058
COAT HANGER HOOK
The coat hanger hook is located on the rear left-hand
cab upright.
CT02C059
Figure 38
Figure 39
3-17