Hydraulic Tank And Engine Fuel Filter - Case 845B VHP Operator's Manual

HYDRAULIC TANK AND ENGINE fUEL fILTER

Hydraulic Tank
WARNING: Fluid under pressure. Turn the
cap (2) slowly to relieve the pressure, before
removing.
Be sure the machine is on level ground with the engine
off. Lower the moldboard to the ground. Check the oil le-
vel through sight gauge (1). The oil level should be at the
center of the gauge. If necessary, remove the hydraulic
tank filler cap (2) and add oil.
1
1. OIL LEVEL GAUGE
2. HYDRAULIC TANK FILLER CAP
CHAPTER 6 – LUBRICATION / FILTERS / FLUIDS
Each 50 hours services
2
fuel filter Draining
Drain the water from the separator filter, proceeding as
follows.
1. Remove the electric connector from the lower part of
the water separator filter.
2. Open the drain valve (2) by turning it completely clo-
ckwise. The drain valve is part of the water presence
sensor connector.
3. Drain the accumulated water until clean fuel drains
out.
4. Close the drain valve and tighten it firmly.
5. Close the drain valve and reinstall the electric con-
nector.
6. Using the filter head manual pump handle (3), pump
until the system is filled again with fuel. A higher resis-
tance will be sensed on the handle.
IMPORTANT: The drain valve is plastic. Do not tighten
excessively when closing.
1
1. WATER SEPARATOR FILTER
2. SEPARATOR FILTER DRAIN VALVE
3. MANUAL PUMP
3
2
6-11