Wiring The Analyzer - Thermo Scientific Orion 2117HL User Manual

Analyzer Preparation

Wiring the Analyzer

Required Tools
Electronics Enclosure
with Cable Glands
Thermo Scientific Orion 2117HL High Level Chloride Analyzer User Guide
Warning: Read and observe the following requirements. If you install the
wrong fuse for your system, you could damage the analyzer. Make sure that
you select the correct fuse rating and discard the additional fuses supplied
in the fuse kit.
• Options kit – includes fuses, cable glands, conduit fitting and green
screw terminal.
• Phillips head screwdriver.
• 2 mm blade flat-head screwdriver.
Figure II-4
4 Captive
Screws
1. Open the faceplate – loosen the four screws using a Phillips head
screwdriver. The electronics faceplate will open via the hinge pin
connection.
2. Remove one or two of the two unused cable glands as required for
wiring power cable or auxiliary connections. Power cable optional hole
locations are shown in Figure II-4.
3. Select and install the appropriate size cable gland or conduit fitting
as required.
4. Feed the power cable through the conduit or cable glands as required.
Hinge Pin
Power Cable
Hole Locations
Cable Glands
Electrode Cables
II-6