Thermo Scientific Orion 2117HL User Manual page 62

Analyzer Operation
Thermo Scientific Orion 2117HL High Level Chloride Analyzer User Guide
Start-Up
1. Restore sample flow to the analyzer. If necessary, adjust the pressure and
flow rate through the analyzer to 40 mL/min.
2. Remove the protective cap from the reference electrode. Re-install the
electrodes on the analyzer. Be careful not to disconnect the reservoir
tubing from the reference electrode sidearm.
3. Allow the analyzer to stabilize for approximately 1 hour and then
recalibrate the system. Refer to Chapter IV, Performing a DKA
Calibration.
III-36