Installing A Raid Adapter Battery Or Flash Power Module Remotely In The Server - IBM 7383 Installation And Service Manual

Installing a RAID adapter battery or flash power module remotely in
the server
Use this information to install a RAID adapter battery or flash power module
remotely in the server.
Before you begin
Note: When you install any RAID adapter that comes with batteries, it is
sometimes necessary to install the batteries in another location in the server to
prevent the batteries from overheating.
Read the safety information in "Safety" on page vii and "Installation guidelines"
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To install a RAID adapter battery or flash power module remotely in the server,
complete the following steps.
Procedure
1. Unlock and remove the left-side cover (see "Removing the left-side cover" on
2. Install the ServeRAID adapter on the system board (see "Installing an adapter"
3. Connect one end of the battery/flash power module cable to the battery/flash
4. Route the remote battery/flash power module cable as shown in the following
page 39).
on page 242).
power module connector.
illustration.
Chapter 2. Installing optional devices
75