IBM 7383 Installation And Service Manual page 255

Note: The cage for the hard disk drive is installed only when you need to
install more than eight hard disk drives. The cage is installed in the bays
where the hard disk drive 16-23 will be installed.
b. Fasten the four screws.
5. Install the 2.5-inch hot-swap hard disk drive backplane (see "Installing the
2.5-inch hard disk drive backplane" on page 277).
6. Install the EMC shields that come with the option.
7. Install the 2.5-inch hard disk drives (see "Installing a 2.5-inch hot-swap hard
disk drive" on page 52).
8. Install the drive bay filler panels that come with the option into empty drive
bays.
9. Connect the backplane configuration cable, power cable, signal cable, and the
configuration cable (see "Internal cable routing and connectors" on page 186).
Chapter 6. Removing and replacing components
237