IBM 7383 Installation And Service Manual page 294

3. Remove the 2.5-inch hot-swap hard disk drives (see "Removing a 2.5-inch
4. Remove the air baffle (see "Removing the air baffle" on page 210).
5. Remove the fan cage assembly (see "Removing the fan cage assembly" on page
6. Note where the power, signal, and configuration cables are connected to the
7. Lift the retention latches that hold the backplane in place; then, grasp the top
8. If you are removing another SAS backplane, repeat steps 6 and 7 to remove the
What to do next
If you are instructed to return the component or optional device, follow all
packaging instructions, and use any packaging materials for shipping that are
276
System x3500 M4 Type 7383: Installation and Service Guide
hot-swap hard disk drive" on page 222).
304).
2.5-inch hard disk drive backplane; then, disconnect them (see "Internal cable
routing and connectors" on page 186).
edge of the backplane and rotate it toward the rear of the server. When the
backplane is clear of the drive-cage retention tabs, remove it from the server.
remaining backplane.