Power Supply (back view)
Using the pull handle, lift up and pull to
release each power supply; then, slide out
the power supply.
Figure 10. Removing and replacing the power supplies and fan and communications module
Mini-hubs (back view)
Loosen the captive screw; then, grasp the screw
and pull the mini-hub from the chassis.
Installing the support rails
To install the controller unit in a rack, use the rails and mounting hardware supplied with
your controller unit.
Where you place the support rails in or on the cabinet depends on where you intend to
position the controller unit.
14
IBM Netfinity FAStT500 RAID Controller Enclosure Unit Installation Guide
Fan and Communications module (back view)
Loosen the captive screws; then, grasp the pull handle and
pull firmly to remove the module.
Figure 11. Removing and replacing the mini-hub