Removing An Optional Serveraid Adapter Memory Module - IBM 7383 Installation And Service Manual

Removing an optional ServeRAID adapter memory module

Use this information to remove an optional ServeRAID adapter memory module.
Before you begin
Read the safety information in "Safety" on page vii and "Installation guidelines"
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To remove an optional ServeRAID adapter memory module, complete the
following steps.
Procedure
1. Carefully turn the server on its side so that it is lying flat, with the cover facing
up.
Attention: Do not allow the server to fall over.
2. Unlock and remove the left-side cover (see "Removing the left-side cover" on
page 39).
3. Remove the adapter (see "Removing an adapter" on page 238).
4. Grasp the memory module and lift to remove it from the connector on the
ServeRAID adapter.
What to do next
If you are instructed to return the component or optional device, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Chapter 6. Removing and replacing components
251