IBM 7383 Installation And Service Manual page 450

Table 39. IMM error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)", that step must be performed only by a trained
technician.
806f0021-2201ffff Fault in slot No Op
ROM Space on
system
[ComputerSystemElementName].
806f0021-3001ffff PCI fault has been
806f0021-3002ffff detected for PCI n. (n
806f0021-3003ffff = PCI slot number)
806f0021-3004ffff
806f0021-3005ffff
806f0021-3006ffff
806f0021-3007ffff
806f0021-3008ffff
432
System x3500 M4 Type 7383: Installation and Service Guide
Error Option ROM
resource allocation
failure. This
message is for the
use case when an
implementation
has detected a
Fault in a slot.
(Sensor = No Op
ROM Space)
Error A PCI fault has
been detected.
Informational message that some
devices might not be initialized.
1. If possible, rearrange the order of
the adapters in the PCI slots to
change the load order of the
optional-device ROM code.
2. Run the Setup utility, select Start
Options, and change the boot
priority to change the load order of
the optional-device ROM code.
3. Run the Setup utility and disable
some other resources, if their
functions are not being used, to
make more space available. Select
Devices and I/O Ports to disable
any of the integrated devices.
4. Replace the following components
one at a time, in the order shown,
restarting the server each time:
a. Each adapter.
b. (Trained technician only) System
board.
1. Check the PCI LED. See more
information about the PCI LED in
Light path diagnostics.
2. Reseat the affected adapters and the
PCI-X interposer card.
3. Update the server firmware (UEFI
and IMM) and adapter firmware.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
4. Remove the adapters.
5. (Trained technicians only) Replace
the system board or the
microprocessor 2 expansion board.