Removing A Drive Carrier Module (2 Of 2); Installing A Drive Carrier Module (1 Of 2) - IBM Small J10 Series Manual

Disk enclosure
Table of Contents

Advertisement

Figure 26. Removing a Drive Carrier Module (2 of 2)
4. Remove the module fully from the drive bay.
Installing a 3.5-inch Drive Carrier Module
Important: A drive carrier module cannot be installed if its anti-tamper lock is activated outside the
enclosure. Refer to the above section for the de-activation procedure.
1. Release the drive carrier handle, by depressing the latch in the handle as shown in the following figure.
Figure 27. Installing a Drive Carrier Module (1 of 2)
2. Put the drive carrier module into the enclosure as shown in the following figure. Make sure that the
drive carrier is in a position so that the drive points up and the handle opens from the left.
38 IBM Cloud Object Storage System: IBM Small J10 Disk Enclosure Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

4957-j104958-j10J10 series

Table of Contents