IBM 7383 Installation And Service Manual page 388

Table 38. DSA messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)", that step must be performed only by a trained
technician.
v Go to the IBM support website at http://www.ibm.com/supportportal to check for technical information, hints,
tips, and new device drivers or to submit a request for information.
Message
number Component Test
166-815-xxx IMM
166-816-xxx IMM
370
System x3500 M4 Type 7383: Installation and Service Guide
State Description
2
IMM I C Test Aborted IMM I
aborted: invalid
data field in the
request.
2
IMM I C Test Aborted IMM I
aborted: the
command is illegal
for the specified
sensor or record
type.
Action
2
C test
1. Turn off the system and disconnect it
from the power source. You must
disconnect the system from ac power
to reset the IMM.
2. After 45 seconds, reconnect the
system to the power source and turn
on the system.
3. Run the test again.
4. Make sure that the DSA code is at
the latest level.
5. Make sure that the IMM firmware is
at the latest level. The installed
firmware level is shown in the DSA
event log in the Firmware/VPD
section for this component.
6. Run the test again.
7. If the failure remains, go to the IBM
website for more troubleshooting
information.
2
C test
1. Turn off the system and disconnect it
from the power source. You must
disconnect the system from ac power
to reset the IMM.
2. After 45 seconds, reconnect the
system to the power source and turn
on the system.
3. Run the test again.
4. Make sure that the DSA code is at
the latest level.
5. Make sure that the IMM firmware is
at the latest level. The installed
firmware level is shown in the DSA
event log in the Firmware/VPD
section for this component.
6. Run the test again.
7. If the failure remains, go to the IBM
website for more troubleshooting
information.