IBM 7383 Installation And Service Manual page 461

Table 39. IMM error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)", that step must be performed only by a trained
technician.
4000000c-00000000 OS Watchdog
response %1 by %2.
(%1 = Enabled or
Disabled; %2 = user
ID)
4000000d-00000000 DHCP[%1] failure,
no IP address
assigned. (%1 = IP
address,
xxx.xxx.xxx.xxx)
4000000e-00000000 Remote Login
Successful. Login ID:
%1 from %2 at IP
address %3. (%1 =
user ID; %2 =
ValueMap(CIM_ProtocolEndpoint.ProtocolIFType;
%3 = IP address,
xxx.xxx.xxx.xxx)
4000000f-00000000 Attempting to %1
server %2 by user
%3. (%1 = Power Up,
Power Down, Power
Cycle, or Reset; %2 =
IBM_ComputerSystem.ElementName;
%3 = user ID)
40000010-00000000 Security: Userid: '%1'
had %2 login failures
from WEB client at
IP address %3. (%1 =
user ID; %2 =
MaximumSuccessiveLoginFailures
(currently set to 5 in
the firmware); %3 =
IP address,
xxx.xxx.xxx.xxx)
40000011-00000000 Security: Login ID:
'%1' had %2 login
failures from CLI at
%3. (%1 = user ID;
%2 =
MaximumSuccessiveLoginFailures
(currently set to 5 in
the firmware); %3 =
IP address,
xxx.xxx.xxx.xxx)
Info A user has enabled
or disabled an OS
Watchdog.
Info A DHCP server has
failed to assign an
IP address to the
IMM.
Info A user has
successfully logged
in to the IMM.
Info A user has used
the IMM to
perform a power
function on the
server.
Error A user has
exceeded the
maximum number
of unsuccessful
login attempts
from a web
browser and has
been prevented
from logging in for
the lockout period.
Error A user has
exceeded the
maximum number
of unsuccessful
login attempts
from the
command-line
interface and has
been prevented
from logging in for
the lockout period.
Appendix C. Integrated management module II (IMM2) error messages
No action; information only.
1. Make sure that the network cable is
connected.
2. Make sure that there is a DHCP
server on the network that can
assign an IP address to the IMM.
No action; information only.
No action; information only.
1. Make sure that the correct login ID
and password are being used.
2. Have the system administrator reset
the login ID or password.
1. Make sure that the correct login ID
and password are being used.
2. Have the system administrator reset
the login ID or password.
443