IBM 7383 Installation And Service Manual page 440

Table 39. IMM error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)", that step must be performed only by a trained
technician.
806f050c-2001ffff Memory Logging
806f050c-2002ffff Limit Reached for
806f050c-2003ffff DIMM n Status. (n =
806f050c-2004ffff DIMM number)
806f050c-2005ffff
806f050c-2006ffff
806f050c-2007ffff
806f050c-2008ffff
806f050c-2009ffff
806f050c-200affff
806f050c-200bffff
806f050c-200cffff
806f050c-200dffff
806f050c-200effff
806f050c-200fffff
806f050c-2010ffff
806f050c-2011ffff
806f050c-2012ffff
806f050c-2013ffff
806f050c-2014ffff
806f050c-2015ffff
806f050c-2016ffff
806f050c-2017ffff
806f050c-2018ffff
422
System x3500 M4 Type 7383: Installation and Service Guide
Error The memory
logging limit has
been reached.
1. Check the IBM support website for
an applicable retain tip or firmware
update that applies to this memory
error.
2. Swap the affected DIMMs (as
indicated by the error LEDs on the
system board or the event logs) to a
different memory channel or
microprocessor (see Memory
module installation for memory
population).
3. If the error still occurs on the same
DIMM, replace the affected DIMM.
4. (Trained technician only) If the
problem occurs on the same DIMM
connector, check the DIMM
connector. If the connector contains
any foreign material or is damaged,
replace the system board (see
Removing the system board and
Installing the system board).
5. (Trained technician only) Remove
the affected microprocessor and
check the microprocessor socket
pins for any damaged pins. If a
damage is found, replace the
system board (see Removing the
system board and Installing the
system board).
6. (Trained technician only) Replace
the affected microprocessor (see
Removing a microprocessor and
heat sink and Installing a
microprocessor and heat sink).