Installing The Usb Cable And Light Path Diagnostics Assembly - IBM 7383 Installation And Service Manual

9. Remove the light path diagnostics assembly (see "Removing the light path
diagnostics assembly" on page 269).
10. Remove the USB cable assembly (see "Removing the USB cable assembly" on
page 272).
What to do next
If you are instructed to return the component or optional device, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.

Installing the USB cable and light path diagnostics assembly

Use the information to install the USB cable and light path diagnostics assembly.
Before you begin
Read the safety information in "Safety" on page vii and "Installation guidelines"
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To install the USB cable and light path diagnostics assembly, complete the
following steps.
Procedure
1. Carefully lay the server down on its side.
2. Unlock and remove the left-side cover (see "Removing the left-side cover" on
page 39).
3. Remove the air baffle (see "Removing the air baffle" on page 210).
4. Remove the fan cage assembly (see "Removing the fan cage assembly" on
page 304).
Chapter 6. Removing and replacing components
267