Installing A Usb Embedded Hypervisor Flash Device - IBM 7383 Installation And Service Manual

8. If you are adding a power supply to the server, attach the redundant power

Installing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.
Before you begin
Read the safety information in "Safety" on page vii and "Installation guidelines"
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To install a hypervisor flash device, complete the following steps.
Procedure
1. Unlock and remove the left-side cover (see "Removing the left-side cover" on
2. Unlock the retention latch by pushing it down toward the system board.
information label that comes with this option on the server cover near the
power supplies.
page 39).
Chapter 2. Installing optional devices
93