Removing A Sas/Sata 8 Pac Hdd Option - IBM 7383 Installation And Service Manual

10. Connect the power and signal cables to the drive and the connectors on the
system board (see "Internal cable routing and connectors" on page 186 for
more information).
11. Install the fan cage assembly (see "Installing the fan cage assembly" on page
306).
12. Install the air baffle (see "Installing the air baffle" on page 211).
13. Close the bezel (see "Closing the bezel media door" on page 185).
14. Install and lock the left-side cover (see "Installing the left-side cover" on page
205).
What to do next
If you have replaced a component or installed an optional device in the server, you
need to reconnect the power cords and all external cables, and turn on the server
and peripheral devices.

Removing a SAS/SATA 8 Pac HDD option

Use this information to remove a SAS/SATA 8 Pac HDD option.
Before you begin
Read the safety information in "Safety" on page vii and "Installation guidelines"
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To remove a SAS/SATA 8 Pac HDD option, complete the following steps.
Procedure
1. Remove the bezel (see "Removing the bezel" on page 206).
2. Remove the left side cover (see "Removing the left-side cover" on page 39).
3. Pull the hard disk drives and filler panels out of the server slightly to
disengage them from the hard disk drive backplane.
4. Remove the 2.5-inch hot-swap SAS/SATA hard disk drive backplane (see
"Removing the 2.5-inch hard disk drive backplane" on page 275).
Chapter 6. Removing and replacing components
235