Removing The Air Baffle - IBM 7383 Installation And Service Manual

Removing the air baffle

Use this information to remove the air baffle from the server.
Before you begin
Note: When you install the second microprocessor, you must also install fan 2 and
the air baffle that come with the second microprocessor upgrade kit.
Read the safety information in "Safety" on page vii and "Installation guidelines"
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To remove the air baffle, complete the following steps.
Procedure
1. Carefully turn the server on its side so that it is lying flat, with the cover facing
2. Unlock and remove the left-side cover (see "Removing the left-side cover" on
3. Remove the air baffle from the server and set it aside.
210
System x3500 M4 Type 7383: Installation and Service Guide
up.
Attention: Do not allow the server to fall over.
page 39).