IBM 7383 Installation And Service Manual page 242

Read the safety information in "Safety" on page vii and "Installation guidelines"
on page 34.
Attention: Static electricity that is released to internal server components when
the server is powered-on might cause the server to halt, which might result in the
loss of data. To avoid this potential problem, always use an electrostatic-discharge
wrist strap or other grounding system when you work inside the server with the
power on.
About this task
To install a 2.5-inch hot-swap hard disk drive, complete the following steps.
Procedure
1. Unlock the left-side cover.
2. Open the bezel (see "Opening the bezel media door" on page 37).
3. Remove the filler panel, if one is present.
4. Touch the static-protective package that contains the disk drive to any
5. Make sure that the tray handle is open; then, install the hard disk drive into the
6. Rotate the drive handle down until the drive is seated in the hot-swap bay and
224
System x3500 M4 Type 7383: Installation and Service Guide
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
unpainted metal surface on the server; then, remove the disk drive from the
package.
hot-swap bay.
the release latch clicks into place.
Note:
a. After you install the hard disk drive, check the disk drive status LEDs to
verify that the hard disk drive is operating correctly. If the yellow hard disk
drive status LED is lit continuously, that drive is faulty and must be
replaced. If the green hard disk drive activity LED is flashing, the drive is
being accessed.