Removing An Adapter - IBM 7383 Installation And Service Manual

10. Install the bezel (see "Installing the bezel" on page 208).
11. Install the left-side cover (see "Installing the left-side cover" on page 205).
12. Reconnect the power cords and any cables that you removed.
13. Slide the server into the rack.
What to do next
If you have replaced a component or installed an optional device in the server, you
need to reconnect the power cords and all external cables, and turn on the server
and peripheral devices.

Removing an adapter

Use this information to remove an adapter.
Before you begin
Read the safety information in "Safety" on page vii and "Installation guidelines"
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To remove an adapter, complete the following steps.
Procedure
1. Carefully turn the server on its side so that it is lying flat, with the cover facing
238
System x3500 M4 Type 7383: Installation and Service Guide
Note: You may need to install the two screws on the backplane configuration
cable.
up.
Attention: Do not allow the server to fall over.