Installing A 3.5-Inch Simple-Swap Hard Disk Drive - IBM 7383 Installation And Service Manual

Procedure
1. Unlock the left-side cover.
2. Open the bezel (see "Opening the bezel media door" on page 37).
3. Slide the blue release latch to the right with one finger (to release the drive)
What to do next
If you are instructed to return the component or optional device, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.

Installing a 3.5-inch simple-swap hard disk drive

Use this information to install a 3.5-inch simple-swap hard disk drive.
Before you begin
Before installing a 3.5-inch simple-swap hard disk drive, read the following
information:
v Inspect the drive tray for signs of damage.
v To maintain proper system cooling, do not operate the server for more than 10
Read the safety information in "Safety" on page vii and "Installation guidelines"
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To install a 3.5-inch simple-swap hard disk drive, complete the following steps.
228
System x3500 M4 Type 7383: Installation and Service Guide
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
while using another finger to grasp the black drive handle and pull the hard
disk drive out of the drive bay.
minutes without either a drive or a filler panel installed in each drive bay.