Removing Sfp Modules; Installing An Sfp Module Into The Host Port; Unlocking The Sfp Module Latch - Plastic Variety - IBM TotalStorage DS4000 EXP100 Installation, User's, And Maintenance Manual

Protective cap
Figure 29. Installing an SFP module into the host port
5. Connect an LC-LC Fibre Channel cable. For information about the LC-LC cable,

Removing SFP modules

Complete the following steps to remove the SFP module from the host port:
Attention:
you unplug the LC-LC Fibre Channel cable before you remove the SFP module.
1. Remove the LC-LC Fibre Channel cable from the SFP module. For more
2. Unlock the SFP module latch:
Protective cap
Figure 30. Unlocking the SFP module latch - plastic variety
Plastic tab
SFP module
see "Using LC-LC Fibre Channel cables" on page 50.
To avoid damage to the cable or to the SFP module, make sure that
information, see "Handling fiber-optic cables" on page 50.
v For SFP modules that contain plastic tabs, unlock the SFP module latch by
pulling the plastic tab outward 10°, as shown in Figure 30.
Plastic tab
o
10
SFP module
v For SFP modules that contain wire tabs, unlock the SFP module latch by
pulling the wire latch outward 90°, as shown in Figure 31 on page 50.
Chapter 2. Installing the EXP100
49