Troubleshooting Monitor Problems - HP j6700 Getting Started Manual

Troubleshooting Your System

Troubleshooting Monitor Problems

Troubleshooting Monitor Problems
In the event that your console does not display or stops displaying to
your graphics device, use the following procedure to set the console for
displaying to an external terminal.
Here are the steps to follow:
1. Turn system power off.
2. Disconnect the computer keyboard connector from the system rear
panel.
3. Connect a serial terminal to the Serial 1 connector (the top serial
connector) on the system rear panel. Configure the terminal for: 9600
baud, No Stop Bits, No Parity, 8 Bits.
4. Power on the system. The system will now display the console to the
terminal connected to Serial 1 port. Note that you can use a 9-pin to
9-pin serial cable (HP F1044-80002) to connect a serial terminal or
terminal emulator on a Personal Workstation or Laptop computer.
5. Set the monitor type and path using the Boot Console Handler. For
information on doing this see the chapter "The Boot Console Handler"
in the Technical Reference.
72 Chapter 3