Table of Contents
Advertisement
7.21. Switches and Jumpers
The product has several jumpers which must be properly configured to ensure correct operation.
Figure 37: Jumper Connector
For a three-pin jumper (see Figure 37), the jumper setting is designated ''1-2'' when the jumper connects pins 1 and 2.
The jumper setting is designated ''2-3'' when pins 2 and 3 are connected and so on. You will see that one of the lines
surrounding a jumper pin is thick, which indicates pin No.1.
To move a jumper from one position to another, use needle-nose pliers or tweezers to pull the pin cap off the pins
and move it to the desired position.
7.21.1. AT / ATX Power Mode Selection (AT_ATX)
The jumper AT_ATX can be used to select AT power mode or ATX power mode.
Figure 38: AT / ATX Power Mode Selection AT_ATX
Table 42: Pin Assignment AT_ATX
Jumper Position
Pin 1-2
Pin 2-3
X
-
-
X
"X'' = Jumper set (short) and ''-'' = jumper not set (open)
www.kontron.com
Description
AT Mode
ATX Mode (Default)
1
2
3
MITX-CFL0 Series - User Guide, Rev. 1.1
// 66
Advertisement
Table of Contents
