Danfoss VLT FC 280 Operating Manual page 85

VLT® Midi Drive FC 280
Operating Guide
Table 40: LCP Copy Messages
Message
0 RPM None
1(1)
Password
0-69 Password Protection
of safety Parameter
[1] Enabled
([0] Disabled)
0 RPM None
1(1)
Copy/Save 0-5 *
0-50 LCP Copy
[ ] 9 Safety Par. from LCP
0 RPM None
1(1)
Safety Par. from LCP
Copying...
00%
0 RPM None
1(1)
Safety Password
Please enter the safety
Password
0 0000000
0 RPM None
1(1)
Pa
0-
Password accepted
[0
([1] Enabled)
0 RPM None
1(1)
Pa
0-
Password rejected
[0
([1] Enabled)
Danfoss A/S © 2022.02
Description
The password protection of the safety parameters is enabled.
Copying the safety parameters from the LCP into the drive is selected.
The safety parameters get copied from the LCP into the drive.
If password protection is enabled in parameter 0-69 Password Protection of Safety Parameters,
enter the correct LCP-copy/parameter mismatch password (parameter 0-68 Safety Parameters
Password).
If the entered password is correct, this overlay message is shown for some seconds.
If the entered password is wrong, this overlay message is shown for some seconds. Then the
password can be entered again.
Safety Functions
AQ381425076031en-000101 / 130R1223 | 85