Danfoss VLT FC 280 Operating Manual page 100

VLT® Midi Drive FC 280
Operating Guide
Bit Name
9 SFBC initialized
10 Safe fieldbus acknowl-
edge request
11 Internal failure
12 Reset Required
13 Pending fail safe state
14 External failure
15 Safe function pending
16 General reset
17 Customization confirmed
18 Customization aborted
19 Customization requested
20 Reserved
21 PUST warning
22–23 Reserved
24–31 Error code
Table 49: Status Word 2
Bit Name
0–1 DI safety status
2–3 Reserved
100 | Danfoss A/S © 2022.02
Description
0: Not in SFBC initialized state.
1: In SFBC initialized state.
Indicating if the PROFIsafe PLC is requesting operator acknowledge or not.
0: No operator acknowledgment requested.
1: Operator acknowledgment requested from safe PLC.
0: No internal failure is active.
1: An internal failure is active.
0: No SFBC reset is required.
1: A SFBC reset is required.
0: No pending fail safe state.
1: In pending fail safe state.
0: No external failure is active.
1: An external failure is active.
0: No safe function is pending.
1: A safe function is pending.
0: No change in state.
1: A General Reset is done.
0: No change in state.
1: Customization confirmed.
0: No change in state.
1: Customization aborted.
0: No change in state.
1: Customization is requested.
–
0: No change in state.
1: A power-up selftest warning is issued.
–
This is the internal or external error codes. 8 bits can indicate 256 different errors. Refer to
6.10.3 Troubleshooting for the definition of the error codes.
Description
00: Inactive
01: Active
10: Pending
11: Error
–
Safety Functions
AQ381425076031en-000101 / 130R1223