Parameter Settings; Changing Parameter Settings With Glcp; Introduction; Changing Parameter Settings - Danfoss VLT FC 280 Operating Manual
Midi drive with functional safety over fieldbus
Hide thumbs
Also See for VLT FC 280:
- Programming manual (144 pages) ,
- Installation manual (96 pages) ,
- Design manual (92 pages)
Table of Contents
Advertisement
VLT® Midi Drive FC 280
Operating Guide
Number
Key
Function
•
21
Reset
Resets the drive manually after a fault has been cleared.
To adjust the display contrast, press [Status] and the [▵]/[▿] keys.
5.3.7 Parameter Settings
Establishing the correct programming for applications often requires setting functions in several related parameters.
Programming data is stored internally in the drive.
•
For back-up, upload data into the LCP memory.
•
To download data to another drive, connect the LCP to that unit and download the stored settings.
•
Restoring factory default settings does not change data stored in the LCP memory.
5.3.8 Changing Parameter Settings with GLCP
5.3.8.1 Introduction
Access and change parameter settings from the Quick Menu or from the Main Menu. The Quick Menu only gives access to a limited
number of parameters.
5.3.8.2 Changing Parameter Settings
Procedure
1.
Press [Quick Menu] or [Main Menu] on the GLCP.
2.
Press [▵] [▿] to browse through the parameter groups, press [OK] to select a parameter group.
3.
Press [▵] [▿] to browse through the parameters, press [OK] to select a parameter.
4.
Press [▵] [▿] to change the value of a parameter setting.
5.
Press [◃] [▹] to shift digit when a decimal parameter is in the editing state.
6.
Press [OK] to accept the change.
7.
Press either [Back] twice to enter Status, or press [Main Menu] once to enter the Main Menu.
5.3.8.3 View Changes
Quick Menu Q5 - Changes Made lists all parameters changed from default settings.
•
The list only shows parameters which have been changed in the current edit set-up.
•
Parameters which have been reset to default values are not listed.
•
The message Empty indicates that no parameters have been changed.
5.3.9 Backing-up/Downloading Parameters
Procedure
1.
Press [Off] on GLCP or [Off Reset] on NLCP to stop the motor before uploading or downloading data.
2.
Press [Main Menu] parameter 0-50 LCP Copy and press [OK].
3.
Select [1] All to LCP to upload data to the LCP, or select [2] All from LCP to download data from the LCP.
4.
Press [OK]. A progress bar shows the uploading or downloading progress.
5.
Press [Hand On] or [Auto On] to return to normal operation.
Danfoss A/S © 2022.02
Responds to an external start command by control terminals or serial communication.
N O T I C E
Commissioning
AQ381425076031en-000101 / 130R1223 | 45
Advertisement
Table of Contents
