Uc360 Used As Teleworker - Mitel UC360 Administration Manual

UC360 Administration Guide

UC360 Used as Teleworker

If MiVoice Border Gateway (MBG) is part of the MCD setup for teleworker, the parameters need
to be set as described in the sections below.
The MBG must also be configured. See the MiVoice Business (MBG) On-line Help.
For detailed information on the physical connectivity, refer to the UC360 Engineering
Guidelines.
Note: For correct operation with the UC360, the MiVoice Border Gateway must be running a
minimum of MBG 7.1 SP1 software or later.
SIP Settings
Account
1. Enter the SIP Server Address — the MiVoice Border Gateway server address.
2. Enter the Username — the SIP users's ID (programmed in MiVoice Border Gateway).
3. Enter the Login Name — the DN.
Video Codec
For a teleworker with a video-enabled UC360 communicating via MiVoice Border Gateway, the
h264highprofile should be disabled. Only h264baseprofile should be enabled. This is
because High Profile is less tolerant to network impairment conditions that can occur over the
public internet.
For the Dial URI functionality, only the h264baseprofile is supported.
Keep Alive Interval
If the UC360 is used as a Teleworker set, the Keep Alive Interval should be set to 10 seconds
to keep the NAT mapping refreshed.
Network Settings
The UC360 Network Settings for MiVoice Border Gateway may be added in manually through
the Settings application or acquired via DHCP. SOHO users will generally need to manually
supplement the parameters given by their DHCP Server such as MiVoice Border Gateway (SIP
Server) address and DNS address.
56