General Information About Settings; Setting Of Numerical Values; Setting With Given Alternatives; Quit And Enter - ESAB A2 PEK Instruction Manual

1 INTRODUCTION
Arrows
Where there is more information behind a row, this is indicated with a black arrow
the text.
SAW
PROCESS
METHOD
REGULATION TYPE
WIRE TYPE
WIRE DIMENSION
CONFIGURATION►
TOOLS►
SET MEASURE
1.4

General information about settings

There are three types of setting:
•

Setting of numerical values

• Setting of given alternatives
• Setting of ON/OFF mode
1.4.1 Setting of numerical values
The settings knobs are used to increase or decrease the set values when setting numerical
values. In the measurements menu, the knobs for welding current / wire feed speed, arc
voltage or travel speed are used.
1.4.2

Setting with given alternatives

Some settings are made by selecting an option from a list. This is an example of the list:
SAW
GMAW
GOUGING
The cursor is positioned on the row for SAW. By pressing ENTER in this position, the SAW
option is selected. If you want to choose another option instead, position the cursor on the
correct row by scrolling up or down using the positioning knob. Then press ENTER. If you
want to exit the list without making a selection, press QUIT.
1.5

QUIT and ENTER

The soft key farthest to the right is used primarily for QUIT, although it is occasionally used
for other functions.
• QUIT returns you to the previous menu or image.
• Pressing ENTER entails the execution of a selected choice in a menu or a list.
The key is called ENTER in this manual.
0460 949 474
MEMORY FAST MODE
- 10 -
behind
SAW
AC
CC
Fe SOLID
0.8 mm
© ESAB AB 2021