Step Function - ESAB A2 PEK Instruction Manual

9 CONFIGURATION MENU
5035 38 RPM
5035 68RPM
FHP 258
VEC80000
VEC40000
DUNKER1
DUNKER2
MET3B
VEC4000Par
4030-350
• GEAR 1 must be set to ON. The value cannot be OFF.
• GEAR 2 must normally be set to ON, but OFF can be selected.
• The values N1 and N2 under GEAR 1 and GEAR 2 are set with one of the three
settings knobs at the bottom of the panel. The interval for N1 and N2 depend on
selected motor.
• The diameter of the feed rollers FEED ROLLER DIAM is selected with any settings
knob. The interval depends on selected motor.
• The encoder for pulses ENCODER-PULSES is selected with any settings knob. The
interval is between 1 - 9998 ppr (ppr = pulses per revolution).
• LOW MANUAL SPEED is selected with any of the settings knobs. The interval is 1 -
1000 cm/min.
• HIGH MANUAL SPEED is selected with any of the settings knobs. The interval is 1 -
5000 cm/min.
9.3.10

Step function

STEP FUNCTION
STEP CONTROL
STEP DIRECTION
STEP LENGTH
STEP SPEED
NUMBER OF STEPS
OVERLAP
MANUAL STEP LENGTH
WHEEL DIAMETER
WELD DIAMETER
ROLL DIAMETER
STEP CONTROL
STEP DIRECTION
STEP LENGTH
0460 949 474
ON or OFF
On/off setting of the step function
SQUARE or TRIANGLE
Setting of direction for the auto step execution
The length of one auto step (minimum setting 1 mm)
- 54 -
ON
TRIANGLE
76 mm
77 cm/min
10
10 mm
3 mm
1 mm
1 000 mm
1 000 mm
QUIT
© ESAB AB 2021