ESAB A2 PEK Instruction Manual page 32

7 FUNCTION EXPLANATIONS
11. External axle, roller bed control, X24.3.
12. Not used, X24.4.
13. Not used, X25.1.
14. Not used, X25.2.
15. Error from external equipment, X25.3.
16. Not used, X25.4.
Digital relay outputs:
1. Roller bed active, X26.2.
2. Boom active, X26.4.
3. Not used, X26.6.
4. Not used, X26.8.
5. Start square direction when external axis is active, X27.2.
6. Start triangle direction when external axis is active, X27.4.
7. Roller bed active, X27.6.
8. Error active that prevent start, X27.8.
Analogue out
1. Speed reference signal in external axis method, 0-10V. X18.
Motor card
Start signal to external equipment's as the power source is located on connector X1.15-16.
0460 949 474 - 32 - © ESAB AB 2021