Configuration Menu; Code Lock; Lock Code Status - ESAB A2 PEK Instruction Manual

9 CONFIGURATION MENU

9 CONFIGURATION MENU
MAIN MENU » CONFIGURATION
This menu contains the following sub-menus:
• Language, see section "Choice of language".
• Code lock, see section "Code lock".
• General configuration, see section "General configuration".
• Machine configuration, see section "Machine configuration".
• Cable lengths, see section "Cable lengths (applies only to LAF and TAF power
sources)".
• Maintenance, see section "Maintenance".
• Measure–values filter factor, see section "Measure–values filter factor".
9.1

Code lock

MAIN MENU » CONFIGURATION » CODE LOCK
When the lock function is activated and you are in the measure screen or fast mode menu, a
password (lock code) is required to exit from these menus.
Code lock is activated in the configuration menu.
CODE LOCK
LOCK STATUS
SET / CHANGE LOCK CODE
9.1.1

Lock code status

In lock code status, you can activate/deactivate the lock function without deleting the existing
lock code in the event you deactivate the function. If no lock code is stored and you try to
activate the code lock, the keyboard is displayed for entering a new lock code.
KEYBOARD
To exit lock status.
When you are in the measure screen or the fast mode menu and the code lock is
deactivated, you can exit these menus without restrictions by pressing QUIT or MENU in
order to go to the main menu.
0460 949 474
A B C D E F G H
I J K L M N O P
Q R S T U V W X Y Z
0 1 2 3 4 5 6 7 8 9
SPACE CAPS
0 (MAX 16)
DELETE
- 39 -
QUIT
SYMBOL DONE
© ESAB AB 2021
OFF