Introduction; The Control Panel; Remote Control Unit; Settings - ESAB Origo A2 Instruction Manual

GB
1

INTRODUCTION

This manual describes operation and use of the A2 control panel, installed in the Arc
4000i & Arc 5000i welding power unit.
For general information on operation, see the power source operating instructions.
1.1

The control panel

1.2

Remote control unit

Using a remote control unit, the primary parameters of the welding process can be
controlled from a device other than the control panel.
Machines with intergral control panels should have program version 1.21 or higher,
in order for the remote control to function correctly.
When the remote control unit is connected, the power source is in remote control
mode; the buttons and knobs are blocked. The functions can only be adjusted via
the remote control unit.
1.3

Settings

Settings
Current
Arc force
Current
Higher current produces wider and deeper penetration into the workpiece.
Arc force
The arc force controls how the current changes when the arc length changes. A
lower value gives a calmer arc with less spatter.
bi06d1ea
1
2
3
Arc 4000i
16 -- 400 A
0 -- 10
- - 7 - -
Yellow indicating lamp -- non--specific fault indica-
tion.
Knob for setting the welding current
Knob for setting the arc force
Arc 5000i
16 -- 500 A
0 -- 10