Figure 27: Power Supply Accessory Items; Table 15: Accessory Items Included With A Power Supply - Allied Telesis x530DP Series Installation Manual

Chapter 4: Installing the Power Supplies
92
Table 15. Accessory Items Included with a Power Supply
Power Supply
PWR150 / PWR150R
PWR250
PWR250-80
PWR800
PWR1200
Power Cord
Retaining Clip
Figure 27. Power Supply Accessory Items
Note
The power cord that comes with the PWR1200 Power Supply for
installations in North America has a 20 Amp, 125 V NEMA 5-20P
plug that is only compatible with an NEMA 5-20R receptacle.
5. Slide the new power supply into slot A or B in the back panel of the
switch. Refer to Figure 28 on page 93.
Please review the following guidelines before installing the module:
If you are installing only one power supply, you may install it in

either slot A or B.
The handle on the power supply should be on the left as you install

the module in the switch. Refer to Figure 28 on page 93.
When installed, the PWR1200 Power Supply extends 5.6 cm

(2.2 in.) from the back panel of the chassis.
The power supply is fully installed in the slot when the tabs with the

captive screws are flush with the back panel of the switch. Light
pressure may be required to properly seat the module on the
power connector inside the chassis.
One Power Cord
Retaining Clip
Yes
Yes
No
Yes
No
Power Cord
3376
One Power Cord
Yes
Yes
No
Yes
Yes